Loading Application Software
Firmware
4 - 18
PPC/PMC-8260/DS1
Primary Booter Commands
The following table shows the commands which can be entered into the SYNC
field, their functions and the necessary parameters.
Table 14:
Primary Booter Commands and Parameters
Command
Description
Necessary Parameters
eras
Erases flash device at the address space
denoted by <CSPC>.
CSPC: Destination address space
(must be 0)
flsh
Initiates flash programming of <CSIZ>
bytes of data stored at offset <COFF>
into memory window at the address
space denoted by <CSPC>, beginning at
flash device offset <CADR>.
COFF: Address of I/O buffer (offset
must be used relative to 01C00000
16
)
CSIZ: Number of bytes to be trans-
ferred
CADR: Destination address
CSPC: Destination address space
(must be 0)
.go!
Starts code execution at local memory
address <ADRS>. This command ter-
minates the primary booter, i.e. all
memory resources used by the primary
booter can be overwritten. For a code
example, see the “Starting Code Execu-
tion” section on page 4-38.
ADRS: Local memory address
ping
Checks alive state of primary booter.
Unless the primary booter is busy with
the previous operation, it will set the
.OK. status immediately as it sees
PING. For a code example, see the
“Checking Alive State of Target” sec-
tion on page 4-37.
Summary of Contents for PPC/PMC-8260/DS1
