Table 19:
PowerSpan II Tests
Offset: 10
16
Status Bit
Description
0 (lsb)
No device was detected at the expected address.
1
Reading the ID register does not return 826010E3
16
.
2
Reading the Subsystem Vendor ID does not return 1146
16.
This indicates a
problem with the serial configuration PROM of the PowerSPAN II.
3
Writing and verifying value 55555555
16
to the DMA0 source address register
failed.
4
Writing and verifying value AAAAAAAA
16
to the DMA0 source address
register failed.
5
Writing and verifying value 0 to the DMA0 source address register failed.
31
Fatal error during test execution
Table 20:
Framer Tests
Offset: 14-20
16
Status Bit
Description
0 (lsb)
No device was detected at the expected address.
1
TYPE section in the ID register is not 001
2
.
2
Data mismatch when accessing register at offset 0
3
Data mismatch when accessing register at offset FF
16
4
Data mismatch when writing 55
16
to register FE
16
5
Data mismatch when writing AA
16
to register FE
16
31
Fatal error during test execution
Obtaining Results from the Power-On Self-Test
Firmware
4 - 28
PPC/PMC-8260/DS1
Summary of Contents for PPC/PMC-8260/DS1
