PPC/PMC-8260/DS1
xxiii
Safety Notes
This section provides safety precautions to follow when installing, operating, and
maintaining the PPC/PMC-8260/DS1.
We intend to provide all necessary information to install and handle the
PPC/PMC-8260/DS1 in this Reference Guide. However, as the product is complex
and its usage manifold, we do not guarantee that the given information is complete.
If you need additional information, ask your Motorola representative.
The PPC/PMC-8260/DS1 has been designed to meet the standard industrial
safety requirements. It must not be used except in its specific area of office
telecommunication industry.
Only personnel trained by Motorola or persons qualified in electronics or elec-
trical engineering are authorized to install, maintain, and operate the
PPC/PMC-8260/DS1. The information given in this manual is meant to com-
plete the knowledge of a specialist and must not be taken as replacement for
qualified personnel.
EMC
The module has been tested in a standard Motorola system and found to com-
ply with the limits for a Class A digital device in this system, pursuant to part
15 of the FCC Rules respectively EN 55022 Class A. These limits are designed
to provide reasonable protection against harmful interference when the sys-
tem is operated in a commercial, business or industrial environment.
The module generates and uses radio frequency energy and, if not installed
properly and used in accordance with this Reference Guide, may cause harm-
ful interference to radio communications. Operating the system in a residen-
tial area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
Summary of Contents for PPC/PMC-8260/DS1
