Allowed Product Combinations
Installation
2 - 8
PPC/PMC-8260/DS1
Allowed Product Combinations
The following tables summarize the allowed product combinations. The PMC
module names are shortened, for example “SC-F” instead of “PMC-8260/DS1-SC-
F”.
Table 6:
PPC/PMC-8260/DS1 on Reference Platforms
Carrier
Board
Slot 1
Slot 2
Backplane-TDM
Bus (PMC Slot)
Line
Inter-
faces
Hard-
ware
TDM-
Mux
(T8105)
Inter-
TDM
Link
PowerCore-
660x
SC-F
-
H.110/SCbus
interoperability
mode (#1)
2
Slot 1: yes
Slot 2: no
No
PowerCore-
6750
SC-F
-
H.110/SCbus
interoperability
mode (#1)
2
Slot 1: yes
Slot 2: no
No
Power-
CoreCPCI
6750
(Rev 2.0
and later)
1) PowerCoreCPCI-6750 Rev. 2.x supports two PMC modules only if it has a certain PCB revision. For
further information, see Table 7 “Revisions Supported by Reference Platform” on page 2-9
1)
H.110-F
H.110-F
H.110 bus (#2)
2 - 4
Slot 1: yes
Slot 2: yes
Yes
MFIO-120
H.110-F
H.110-F
H.110 bus (#2)
2 - 4
Slot 1: yes
Slot 2: yes
Yes
Note: As described in the table above, the reference platform PowerCoreCP-
CI-6750 Rev.2.x supports two PPC/PMC-8260/DS1 modules, depending on
the hardware revision. The supported hardware revisions are listed in the fol-
lowing table. Hardware revisions earlier than those listed below support only
one PMC-8260/DS1. Therefore, if you want to install two PMC modules, make
sure to order the CPCI-6750 Rev. 2.x with the minimum PCA revision level
given in the table.
Summary of Contents for PPC/PMC-8260/DS1
