User Guide: PTP 600 Series
Task 7: Configure wireless interface
phn-0896_012v000
Jul 2010
6-57
Attribute
Meaning
Target MAC
Address
This is only displayed when Access Method is set to ‘Link
Access’. This is the MAC Address of the peer unit that will be
at the other end of the wireless link. This is used by the
system to ensure the unit establishes a wireless link to the
correct peer. The MAC Address can be found embedded
within the serial number of the unit. The last six characters of
the serial number are the last three bytes of the unit’s MAC
address.
NOTE
A PTP 600 Series system is shipped as a pair of units with
pre-loaded correct MAC addresses. Target MAC
addresses will only need to be entered if an existing unit
has to be replaced in the field or the units configuration
has been erased.
Dual Payload
This controls whether the link takes advantage of the channel
condition to increase the link throughput. If set to ‘Disable’,
the robustness of the link is improved. The default value is
‘Enabled’.
This control is automatically set to ‘Enabled’ if either E1 or
T1 is enabled and Lowest Telecoms Modulation Mode is set to
a Dual Payload modulation.
Master Slave
Mode
At this point it is necessary to decide which end will
designate a Master. The Master unit is the controlling unit
with respect to the point-to-point link and its maintenance.
The master transmits until the link is made, while the Slave
listens for its peer and only transmits when the peer has been
identified.
Link Mode
Optimization
Optimizes the link behavior according to the type of traffic
that will be bridged. There are two modes to choose from: IP
and TDM. For more information, see
Link mode optimization
on page
1-25
.
TDD
Synchronization
Mode
Enables the TDD synchronization feature. See
TDD
synchronization
on page
1-33
for basic description and
Step
3: TDD synchronization (optional)
on page
6-64
for
installation and configuration details.
4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299