Switch Information
3-23
3.2.5 Editing Port PoE Settings
To modify the PoE settings for a port:
1. Select a port to edit from the table.
2. Click the
Edit
button.
The
PoE Edit
screen shows the port PoE status, Priority, and Power Limit.
3. Check the
Enable PoE
checkbox to configure the selected port to use Power over Ethernet. To disable
PoE on a port, uncheck this box.
4. Select the
Priority
level for PoE on this port. The
Priority
level is used in cases where the switch’s PoE
power consumption exceeds the available power. When this happens, ports with higher
Priority
levels
will be given precedence over those with a lower
Priority
level.
5. Set the
Power Limit
(in watts) for this port’s PoE usage. Setting the
Power Limit
places a cap on the
maximum amount of power which can be drawn from the selected port.
6. Click
OK
to save and add the changes to the running configuration and close the dialog.
Priority
Displays the priority mode for each of the PoE ports.
The priority options are:
• Critical
• High
• Low
Limit (watts)
Displays the power limit in watts for each of the PoE ports. The maximum power
limit per port is 36 watts.
Power (watts)
Displays each PoE ports power usage in watts.
Voltage (volts)
Displays each PoE ports voltage usage in volts.
Current (mA)
Displays each PoE ports current usage in milliamps.
Status
Displays the operational status for each PoE port. Ports can be either
On
or
Off
.
NOTE:
Power limits and power budgets are based on worst case operating conditions to
deliver power at the level requested. The worst case operating conditions assume the
switch is operating at its maximum operating temperature and at a maximum cable
length. As a result power levels may be between 5% and 10.5% over requested level.
Summary of Contents for RFS Series
