8
RS309 Scanner
6.
To replace the access cover, align the knobs on the cover with the notches
inside the desiccant well, and turn the cover clockwise 45° using the coin.
Replacing the Protective Cap
To replace the protective cap that covers the RS309:
1.
Remove all cables connected to the RS309 and remove the RS309 from any
mounting equipment.
2.
Push up on the recesses between the protective cap and the scanner (located
underneath the exit window) until the tabs on the scanner pop out.
3.
Lift the protective cap off the RS309.
4.
Slide the RS309 into the back of the new protective cap so the connectors
appear through the back opening of the protective cap.
5.
Push the front of the RS309 into the protective cap until it snaps into place.
Recess Area
Tabs