Using the Debugger With the X Window System
3-9
Installing the Simulator and C Source Debugger With HP-UX
3.5
Using the Debugger With the X Window System
If you’re using the X Window System to run the ’C2xx debugger, you need to
know about the keyboard’s special keys, the debugger fonts, and using the de-
bugger on a monochrome monitor.
Using the keyboard’s special keys
The debugger uses some special keys that you can map differently from your
particular keyboard. Some keyboards may have these special symbols on
separate keys. Other keyboards do not have the special keys.
The special keys that the debugger uses are shown in the following table with
their corresponding keysym. A
keysym is a label that interprets a keystroke;
it allows you to modify the action of a key on the keyboard.
Key
Keysym
F1
to
F10
F1 to F10
PAGE UP
Prior
PAGE DOWN
Next
HOME
Home
END
End
INSERT
Insert
→
Right
←
Left
↑
Up
↓
Down
Use the X utility xev to check the keysyms that are associated with your key-
board. If you need to change the keysym definitions, use the xmodmap utility.
For example, you could create a file that contains the following commands and
use that file with xmodmap to change a keyboard to match the keys listed
above:
keysym R13
= End
keysym Down
= Down
keysym F35
= Next
keysym Left
= Left
keysym Right
= Right
keysym F27
= Home
keysym Up
= Up
keysym F29
= Prior
keysym Insert = Insert
Refer to your X Window System documentation for more information about
using xev and xmodmap.
Summary of Contents for SCOUTTRAINER25
