26
SE-1010 / SE-2000 Encoder Product Manual, Version 1.0
Reset Menu
Use the Reset menu to reset presets 1 to 30 back to the factory-defined defaults.
CAUTION
The following procedure deletes all user-defined configurations and returns all values to
the factory-defined defaults as shown in Table 1 on page 9. This procedure does not clear
the Status Log which is described on page 25.
To reset the SE encoder
1.
Navigate to the RESET menu as shown below and press the ENTER button.
2.
Verify that the following message is displayed:
3.
To reset the encoder to factory-defined presets, press ENTER twice.
or
To exit this LCD screen without resetting the encoder, press the left arrow button and
then the down arrow button.
Software Version
This menu displays the product name (SE-1010 or SE-2000) and the software version
number.
•
S E - 2 0 0 0 V e r 1 . 0 0 / 1 . a
M o t o r o l a B C S
•
R e s e t t o F a c t o r y P r e s e t s ?
P r e s s E N T E R t o
c o n f i r m , < | > t o r e j e c t .
•
> S E – 2 0 0 0 R E S E T
< > E
E N T E R R e s e t s T o F a c t o r y P r e s e t s !