Disconnecting from Bluetooth Devices
1
When the Bluetooth accessory goes out of range or
turn off, it will be disconnected from the radio
automatically.
The radio sounds an indication tone after
disconnected from the Bluetooth accessory.
2
The radio attempts to reconnect to the same
Bluetooth accessory within a reconnect timer.
Clearing Bluetooth Pairing
1
Press the
Power/Info
button until you see the
Bluetooth icon.
2
Scroll through the bluetooth list using
Talkgroup/
Contact List Scroll Rocker
or
Volume Up and
Volume Down
buttons until the right bluetooth is
displayed.
3
On the device "friendly" name, press and hold the
Menu/Programmable
button to clear the pairing.
If clearing the bluetooth pairing successfully, a positive tone
sounds.
If clearing an unpaired device, a negative tone sounds.
Scan
This feature allows your radio to cycle through the
programmed scan list for the current channel looking for
voice activity.
When in the scan mode, the system preempts an ongoing
low-priority talkgroup call. Your radio unmutes to the high-
priority talkgroup call. You respond to the active talkgroup
when you press the PTT button during the programmed
period (hang time) of an ongoing call from your scan list.
Pressing the PTT button when the radio is not in a call,
causes the radio to start a call on the last selected
talkgroup.
NOTICE:
If the DND mode is enabled during the scan mode,
your radio prioritizes the DND mode.
English
43