Appendix A- 8
level at the radio standard antenna port to 1mV (-47dBm)
modulated with 3.0 kHz FM deviation of a 1 kHz tone.
12.Use the UP/DOWN arrow keys to obtain a discriminator level
between 206 - 218mVrms (target value of 212 mVrms) observed on
the ac volt-meter.
13.Press F8 to program the softpot value.
14.Press F10 to return to the RECEIVER menu.
Removal And Installation
Refer to Appendix Figure 2, Secure Module Location Detail, when
adding, removing, or replacing the secure module and/or secure
module pad. Notice the orientation of the secure module and the
secure module pad to the controller board.
Removal
Perform the disassembly procedure outlined in Section 6, up to and
including removing the radio’s front shield. Remove the secure
module by pulling it out and away from the controller board.
NOTE:
The secure module and the controller board
connect via a plug and jack located at the
opposite corner from the round popple switch.
Remove the secure module pad as necessary.
Replacement/Installation
Perform the disassembly procedure described in the preceding
paragraphs. Refer to Appendix Figure 2 for secure module pad and
secure module board orientation. If the secure module pad was
removed, place the removed pad or a new pad (Motorola part number
7505670Z01) on the controller board and ensure that it seats flush
with the controller board on all sides. Place the secure module on the
secure module pad. Press the secure module plug into the controller
board jack with enough force so that the jack and plug snap together.
Reassemble the radio per the procedure outlined in Section 6 of this
manual.
Summary of Contents for SYMBOL MT2000 Series
