33
NOTE: A large portion of the controls flex is attached to the
large metal shield (front shield) with adhesive. Do not
remove the controls flex from the front shield.
9. As a unit, separate the control top, the front shield, and the
controls flex from the chassis and circuit boards (see Figure 8).
NOTE: Three locking clips (four tabs on early front shield)
secure the front shield to the chassis and hold the RF
board and the controller board in the chassis.
a. Loosen the front shield by prying each of the three clips (four
tabs on early front shield) away from the chassis. Be careful
not to pry the clips/tabs any more than is necessary to free
them from their respective retaining slots. To completely
loosen the shield from the chassis, a slight lifting and
clockwise twisting action may be required.
b. Insert a small, flat-blade screwdriver in the recessed area of
the control top and pry the control top slightly away from the
chassis.
c. Completely remove the control top/front shield/controls flex
unit from the chassis.
10.Carefully remove the RF board and the controller board from the
chassis.
Figure 8 Separating Control Top From the Chassis
Four (4)
Large Tabs
Controls
Flex
Front
Shield
PTT Switch
Area
Control
Top
MAEPF-22574-A
Recessed
Area for
Prying Loose
Three (3)
Locking Clips
Controls
Flex
Front
Shield
PTT Switch
Area
Control
Top
MAEPF-27017-O
Recessed
Area for
Prying Loose
Unit with
early Front Shield
Unit with
latest Front Shield
Summary of Contents for SYMBOL MT2000 Series
