34
NOTE:
The RF board and the controller board are
connected together with a stiff connector strip
(P301/P704. See Figure 9.
Disassembly of
Control Top
1. Remove the rubber controls seal from the control top.
2. Turn the control top such that the grey switch housing cover is
facing up.
a. Five retaining clips hold the switch housing cover to the
switch housing. Clips 1, 2, and 3 are important during
disassembly (see Figure 10).
NOTE:
To perform step 2b, two tools will be required;
your thumbnail or small, flat-blade
screwdriver, and a pen, pencil, or another
small, flat-blade screwdriver.
b. Using your thumbnail or small, flat-blade screwdriver, lift the
tab that covers the base of the LED approximately 1/16 of an
inch from its seated position. While applying constant lifting
pressure there, (in order) release clips 1, 2, and 3 with the
other tool.
c. The cover will pop loose from the switch housing.
3. Push the three switches and the LED out of the switch housing.
MAEPF-22575-A
Chassis
Connector
Strip
RF Board
Controller
Board
Figure 9 Removing the RF and Controller Boards
Switch Housing
Cover
Switch
Housing
Lift
Tab
Clip 1
Clip 2
Clip 3
Clip 4
Clip 5
MAEPF-22576-O
Figure 10 Switch Housing Retaining Clips
Summary of Contents for SYMBOL MT2000 Series
