37
2. Press the rubber microphone boot into its respective recessed area
in the front cover housing. The little rubber flap in the back of the
rubber boot should fold up to cover the microphone insertion
opening.
3. Reinstall the speaker retainer bracket (see Figure 13).
a. Position the spring bracket over the speaker, and toward the
top of the front cover housing; insert the appropriate two legs
of the bracket into their respective slots.
b. Grasp the center portion of the spring bracket (ring area) with
thumb and forefinger.
c. While holding the ring area of the spring bracket at
approximately the same height as the speaker’s base, push the
remaining leg down and into its respective slot.
4. Orient the wedge connector so that its gold contacts face the gold
contacts of the housing. Align the wedge connector with the
respective slots in the housing, and slide the connector down into
place. Ensure that the wedge connector is fully seated into
position.
1. Inset Legs
Into Slots
2. Grasp Clip
Here and Here,Then Push Leg Into Slot
MAEPF-22578-A
Figure 13 Reinstalling the Speaker Retainer Bracket
Summary of Contents for SYMBOL MT2000 Series
