CHANGE/VIEW
MTSX RSS
6-42
68P81074C50
FIELD DEFINITIONS:
Failsoft Inactivity (sec)
This field pertains to failsoft operation. If a radio remains inactive while operating in failsoft for this specified time
(in seconds), the radio will momentarily leave failsoft and attempt to find a control channel. A value of zero here
indicates that the radio will not leave failsoft. The valid range is 0 to 255 in 1 second increments.
Factory default is 120.
Busy Override Delay (sec)
This field specifies the time interval (in seconds) during which the user must depress the PTT button in order for
the radio to issue a busy override signal. The valid range is 2 to 6 in 1 second increments.
Factory default is 4.
Aff. (affiliating) Hold Off (sec)
This field is the time (in seconds) that the radio should delay before affiliating at a new site when leaving a site
which just incurred a failure. The valid values are 1, 3, 7, 15, 31, 63, 127, and 255 in 1 seconds.
Factory default is 63.
Busy Override Chirp Ack
Setting this bit causes the radio to produce a chirping sound after a busy override has been issued.
Factory default is On.
Display Site Trunking
Setting this bit causes the radio to display the "Site Trunking" message when the user is locked onto a site that is
in site-trunking mode.
Factory default is On.
Full Spectrum CC Scan
Setting this bit causes the radio to perform a full spectrum Control Channel scan when the radio goes out of
range of all its programmed Control Channel information. Full spectrum scan searches the entire frequency band
(800 MHz, 900 MHz, band 1 UHF band, or VHF) for a control channel for the radio to lock onto. This is used
when the radio cannot find a control channel on any of the frequencies programmed on the RSS.
Factory default is OFF.
Full Spectrum CC Scan Timer (sec)
This is the amount of time (in seconds) the radio has to perform full spectrum CC scan before returning to the
normal CC scan. The valid range is 5 to 31 seconds.
Factory default is 10.
RSSI Acceptable Threshold
Use the UP/DOWN arrows to make your selection or enter a value directly. In the RSSI sampling scheme, RSSI
values are separated into four levels -- poor, acceptable, good and excellent – as shown (i.e.: all values below the
acceptable constant fall into the POOR level, values between the acceptable and good constants fall into the
ACCEPTABLE level, etc.). The value in this field specifies the POOR/ACCEPTABLE boundary. Domain {L: 00 <=
L <= FF}.
The default is 61
Summary of Contents for SYMBOL MT2000 Series
