70
GPS Enable/Disable
(
9 2)
1.
From the main menu, press
9 Location – 2 Interface
.
The current selection (On/Off) is highlighted. The display
shows:
On
— Location Service On
Off
— Location Service Off
2.
Scroll to your selection and press
Set
.
If GPS is enabled but the radio is not
synchronized to the GPS satellites the
following idle screen is displayed:
Entering GPS Location Service
(
9)
To enter the GPS sub-menu, press
– 9 Location
.
Position
— provides the actual position
information.
Interface
— allows you to enable/disable the GPS location
service.
This estimate of accuracy of the calculated location is only a
very rough estimate and may vary substantially from the
actual accuracy of the approximate location information
reported.
Viewing Your Position (
9 1)
1.
From the main menu, press
– 9 Location – 1 Position
.
2.
This displays the following information about the last time
your location was calculated (if available):
UTC
— The
time
the location was last calculated.
• The variation will vary in accordance to the GPS
Configuration set by your Service Provider.
• The availability of the GPS Location menus is dependent on
your terminal configuration, please contact your Service
Provider for further details.
Menu
Menu
Status
Optios
1 Position
Range 1
No GPS signal
Menu
Back
2 Interface
Ok
1 Position
Menu
Menu
Menu
6815321H01_KOR.book Page 70 Thursday, November 13, 2008 8:06 AM
