93
The
Men
u
Scan
(
7)
To enter the sub-menu, press
– 7 Scan
.
This sub-menu allows you to activate/deactivate scanning,
view the active scan list, and edit the scan lists.
Setting Talkgroup Scanning (
7 1)
To enter the sub-menu,
press
– 7 Scan – 1 Scanning
.
This sub-menu allows you to activate/
deactivate the scanning of a list of
predefined talkgroups programmed in the MTM800. The
MTM800 will join any talkgroup call as long as this talkgroup
is defined in the scan list and scan is turned on.
Scroll to the desired setting and press
Ok.
If it is set to
Off
, display shows the
following state:
When set to
On
, the display shows the
following state:
• The last selected scan list, or
• the first list in the scan lists.
To select a list other than the one shown,
scroll through the scan lists and press
Set
.
To change your selection:
• Select
– 7 Scan – 1 Scanning – 1 SelectList
,
or
• Enter Group mode and select
Optns – Scan – 1 SelectList
.
A message indicating that all scan lists are empty.
Select
3 Scan Lists
to fill the scan list(s). See page 94.
When set to
Off
,
scanning is deactivated.
It is not possible to enable or disable Talkgroup scanning in TXI
Mode.
Menu
Menu
Menu
2 Active List
Back
Ok
1 Scanning
3 Scan Lists
Menu
2 SelectList
1 On
Back
Ok
Back
Ok
1 Off
2 SelectList
Scan List 1
Scan List:
Back
Set
Menu
6815321H01_KOR.book Page 93 Thursday, November 13, 2008 8:06 AM
