28
Remote Control Programming
Getting Started
Install Batteries in Your Remote Control
•
The remote control requires two AA-size alkaline batteries (1.5V) batteries
•
On the back of the remote, push down on the tab and lift off the cover
•
Match the batteries to the + and - marks inside the battery case, then insert two
AA alkaline batteries
•
Press the battery cover back into place
•
Test the remote control by pressing the STB/MTS key. The STB/MTS key should
light up if the batteries are properly inserted
Program your MTS Ultimate TV Remote to Control
your TV, DVD, Home Theatre Receiver, or Other Devices
You can program your MTS TV Remote to control other devices using the
TV
,
DVD
,
and
AUX
mode keys.
User Tip:
The DVD and AUX mode keys can be setup with codes for any type
of equipment. The TV mode key can only be setup with TV codes. If you have a
combination unit, such as a TV/DVD unit, each component of the unit will normally
be programmed separately.
Manually Program the TV, DVD, or AUX mode keys using direct
code entry:
1. Power on the device you want to program. Locate the 4-digit set up code for
the device you want to program from the Manufacturer Code List
2. Press and hold the appropriate mode key (TV, DVD, or AUX) on the remote
control
Black MXv4 (with MTS logo) Remote Only:
3. Enter the first code for your brand from the code list using the number pad on the remote
4. Press
POWER
key to test with your device. If the device turns off, setup is complete
5. If device does not turn off, repeat steps 3-5 using the next code for your brand of device
6. Repeat the steps to program another device
Black MXv3 Silver and Charcoal Remotes:
3. Without releasing the chosen mode (
TV
,
DVD
, or
AUX)
key, press and hold the
OK
key simultaneously
4. Release both the mode key and the
OK
key – all the mode keys should flash twice on the silver or charcoal
remotes. On the black remote the selected mode key will stay lit
5. Enter the 4-digit set up code by pressing the number keys (0-9) on the remote control
•
On the silver/charcoal remote the mode key will flash three times indicating correct entry and return to normal
operation. On the black remote the selected mode key light will blink for each digit entry and will remain off
after the entry of the fourth digit indicating a successful setup
