32
Troubleshooting Learning (Black MXv3 & MXv4 Remotes Only
)
•
No functions may be stored under the
LEARN/SETUP
key, or in the
STB/MTS
mode
•
Depending on the remote you are trying to learn from, some keys may not be teachable
•
Only one original device type can be learned per individual mode
•
Use fresh batteries for your original remote, and your MTS TV remote control
•
Keep at least three feet away from incandescent or low energy lights when learning
•
Point your original remote so the infrared elements on both remotes are directly in line with each other. You may
need to adjust the height of the remotes to achieve this
•
If you keep experiencing errors while learning the first or second keys for a mode, then try the following:
•
End the learn session by pressing the
LEARN/SETUP
key
•
Clear out the learned commands for that mode
•
Check the infrared elements of the two remotes are correctly aligned
•
Change the distance between the two remotes to be either closer (half an inch) or further away (2 inches) from
each other
Try learning the original remote for that mode again. If problems reoccur with the same key, check the original remote
key being learned – does it transmit? Does it operate the target device?
Try learning that key under a different clear mode. If it learns, then it is likely a different code type from the others and
cannot be learned under the same mode.
Set Volume Options for Multiple Devices
The default setting for your power, volume, and channel control are to control your MTS TV set-top box regardless of the
mode you are in. For example, even in DVD mode, the volume will still control the set-top box.
Volume Control Set Up Options for Multiple Devices
•
The volume commands are sent to the set-top box unless the TV mode key has been programmed
•
If the TV mode key has been programmed, the volume commands are sent to the TV from all mode keys
•
If you’d like the volume commands to be sent to just one device – for example, to your home theatre set up and
not to the MTS TV set-top box or TV set – follow the instructions in
Lock the Volume Controls to One Device
•
If you’d like the volume command sent to different devices depending on which mode you are in, go to
Volume
Control Depends on Device Selected
Lock the Volume Controls to One Device
Silver/Charcoal Remote:
1. Press and hold the
STB/MTS
key and hold the
OK
key simultaneously on the remote control
2. Release both the
STB/MTS
key and the
OK
key – all the mode keys will flash twice indicating programming mode
3. Enter
955
by pressing the number keys on the remote control – the
STB/MTS
key will flash twice indicating correct
entry
4. Press the mode key (
TV
,
DVD
, or
AUX
) that you want to always receive the volume commands. The selected mode
key will flash three times indicating successful assignment and return to normal operation
The volume commands will now go to the selected device no matter what mode you are in
Black MXv3 Remote:
1. Press the
TV
key and while holding it pressed, press the
OK
key for 1 second
2. Release both keys, all of the mode keys will flash followed by the TV mode key light remaining on
3. Press and hold the
MUTE
key for 3 seconds until the
TV
mode key light briefly turns off then remains on. Press
and release the mode key you want to always operate the volume commands (
STB/MTS
,
TV
,
DVD
, or
AUX
). The
selected mode key light will remain on
