2 Safety Instructions
Rev. 02/2018
11
–
Operate the equipment only while it is in proper condition.
–
Investigate all changes detected while operating the gas engine or ignition system.
–
Ensure compliance with all laws, directives and regulations applicable to the operation of
your system, including such not expressly stated herein.
–
If the system is not entirely tight and sealed, gas may escape and result in explosion hazard.
The inhalation of gas can also lead to death or severe health damages. Therefore, upon
completion of all assembly works, always check the system's tightness.
–
Always ensure adequate ventilation of the engine compartment.
–
Ensure a safe position at the gas engine.
2.2
Electrostatic Discharge Hazards
Electronic equipment is sensitive to static electricity. To protect these components from damage
caused by static electricity, special precautions must be taken to minimize or prevent
electrostatic discharge.
Observe these safety precautions while you work with the equipment or in its vicinity.
–
Before performing maintenance or repair work, ensure that the static electricity inherent to
your body is discharged.
–
Do not wear clothing made from synthetic materials to prevent static electricity from
building up. Your clothing should therefore be made of cotton or cotton mix materials.
–
Keep plastics such as vinyl and Styrofoam materials as far away from the control system, the
modules, and the work environment as possible.
–
Do not remove the circuit boards from the housing of the device.
Summary of Contents for PoewerView3
