8 General Operation
66
Rev. 02/2018
Access level
Rights
Service
–
Operator rights
–
Complete display configuration
–
Change the node ID and the bit rate of the PowerView3
–
Activate device types
–
MIC3, MIC3+, MIC4, MIC4+, MIC5, MIC5+:
–
Energy Adjustments
–
Ignition timing adjustment
–
Self Test
–
Set engine operating hours
–
Set the spark plug operating hours
–
Change TempScan20 settings
Master
–
Service rights
–
Enable/Disable access control
–
Reset all PINs
–
Firmware update
–
Transmit LSS commands
Access to locked functions
If you would like to access a function with enabled access control, which
exceeds your currently set rights, you will be prompted to enter the PIN for
the access level required.
8.5.1
Enabling/Disabling Access Control
Access control in as-delivered state
In as-delivered state, the access control is not enabled and all PINs are set
to
. After enabling the access control, assign an individual PIN for each
access level including
Master
(see
Changing the PIN
Summary of Contents for PoewerView3
