9 Devices
108
Rev. 02/2018
9.2.5
Preferences
The
Preferences
button in the
Main Menu
of the added DetCon detonation controller opens the
Preferences
view.
In this view you change the settings for processing the signals that the PowerView3 receives
from the DetCon detonation controller.
Sensor Order
In the factory settings, the knocking intensity of all cylinders is displayed in the
Knocking
Intensity
view (see section
Intensity
on page 104). The sequence depends on the DetCon
detonation controller sensor output that the relevant detonation sensor is connected to. Tap
Set
to change the sequence or to display the knocking intensity of only a selection of the sensors.
Trip Handling
Activate the checkbox to invert the status display
Trip
in the
Overview
of the DetCon detonation
controller (see section
Overview
on page 102). This setting does not change the setting of the
Trip contact inactive
entry in the DetCon detonation controller.
Binary Outputs
If the binary outputs of the PowerView3 are activated in the
Device Setup
view (see section
Devices
on page 51), you can activate the following messages:
–
Warning on Knocking
If the DetCon detonation controller registers engine knocking, binary output 1 (Warning) is
switched on the PowerView3.
Summary of Contents for PoewerView3
