6 Installation Instructions
Rev. 02/2018
33
6.2
Installation
Use in potentially explosive atmospheres
For use in a hazardous area of Class I, Division 2, Groups C and D, T4 in the
USA and Canada, it is imperative that you observe the information of the
CSA Certificate 2173514 (see section
Certifications
on page 15) for the
PowerView3.
The PowerView3 is designed for installation in a control cabinet door. Install the device as
follows:
Installation by two people
MOTORTECH recommends that the PowerView3 is installed by two people.
1.
Select a suitable place for the PowerView3. When selecting observe the following points:
–
The display must be easily visible and accessible for the user.
–
The interfaces of the device must not be covered by other components and wires (even
when the door of the control cabinet is closed).
–
When the door of the control cabinet is closed, a minimum distance of 50 mm (2") to
other components and cables must be maintained.
–
The device front has larger dimensions than the cut-out dimensions (see
Overview
Drawings
on page 26).
Summary of Contents for PoewerView3
