7 Wiring of the Device
42
Rev. 02/2018
7.2
Binary Inputs/Outputs
Operational safety!
The PowerView3 and the software are not designed for safety-critical
applications. The binary inputs and outputs of the PowerView3 must not be
used for safety-critical purposes.
If warnings and errors occur in the detonation controller or in a temperature module, two binary
outputs can be switched at the PowerView3. Binary output 1 is used for signalling warnings,
binary output 2 for signalling errors. The binary inputs and outputs are galvanically isolated. The
binary outputs can be activated in the PowerView3 in the
Device Setup
view. For this, refer to the
section
Devices
on page 51. The binary inputs of the PowerView3 are without function.
Pin
Assignment Description
Level
GPI1
Input 1 (no function)
Low: 0 V, High: 3 V to 36 V
8.3 mA at 24 V typical
GPI2
Input 2 (no function)
Low: 0 V, High: 3 V to 36 V
8.3 mA at 24 V typical
Binary Com Ground for binary IO group
GND
Device ground
Negative potential of the device
operating voltage (L-)
GPO1
Output 1 – Warning
Low: 0 V, High: corresponds to
Max. 800 mA at 24 V
GPO2
Output 2 – Error
Low: 0 V. High: corresponds to
Max. 800 mA at 24 V
Binary
Power in
Supply input for binary IO
group
< 36 V
Binary
Power out
Supply output for binary IO
group
Positive potential of the device
operating voltage (L+)
Summary of Contents for PoewerView3
