info@motorvac.com www.motorvac.com
Dipstick Exchange
Warning:
It is not necessary to empty the waste tank before beginning an exchange. If beginning an
exchange with fluid in the waste tank ensure that there is less fluid in the clean tank than the remaining
capacity of the waste tank. Failure to do so will result in waste tank overflowing!
1. Fill the TransTech IV+ new fluid tank with the correct type and amount of Transmission Fluid.
2. Connect TransTech IV+ power leads to the vehicle’s battery.
3. Ensure flow direction switch is in position A.
4. Press
MODE
button to select Dipstick operation. Dipstick indicator will be illuminated.
5. Check the transmission fluid level. The Transmission fluid level can be adjusted at this time using the
DRAIN
or
FILL
buttons. This will ensure the service completes with the correct amount of fluid in the
transmission.
6. Measure the vehicle dipstick and set spacer on dipstick fill tube/drain tube on TransTech IV+ to the
correct length. Insert the TransTech IV+ tube into the vehicles dipstick tube.
7. Press
START/RESUME
button to begin service.
10
