8.
As shown in the next figure, connect the appropriate adaptors at the points listed in
Step 7
.
9.
As shown in the previous figure, attach the T-adaptor (#060-4500) and the loop
adaptor (#060-2501) as follows:
•
Attach the ends of the T-adaptor (#060-4500) to both pressure line adaptors, then attach the output
(
red
) hose to the center connection on the T-adaptor.
•
Attach the loop adaptor (#060-2501) to both return side adaptors. The return (
black
) hose on the unit
is not used at this time.
10. Start the vehicle
and check connections for leaks. Watch the
Fuel Pressure
gauge on the control panel
to test system pressure, since pressure loss could indicate a leak.
DIAGNOSTICS
The vehicle’s fuel system is now prepared to perform
diagnostic tests if desired. For instructions on how to
perform these tests, go to the next chapter titled Vehicle
Diagnostics.
If vehicle diagnostics are not desired, continue the cleaning
procedure beginning with Step 11 below.
FILTER
PRESSURE LINE
➩ ➩ ➩
RETURN LINE
➩➩
➩
RED HOSE
BLACK HOSE
ADAPTOR
060-4500 " T "
ADAPTOR
THROTTLE BODY UNIT
ADAPTOR
ADAPTOR
060-2501
"LOOP"
FUEL TANK
