The MBxXSe electric minibike is equipped with a special switch that reduces
the speed to accommodate younger, smaller riders. The switch is located
inside the battery case, under the battery in a hard to reach spot to limit
access by inquisitive smaller children.
NOTE: THE SLOW SPEED SAFETY SWITCH IS SET AT THE FACTORY
TO THE SLOWER SPEED.
To switch from slow speed to regular speed, or
vice-versa, follow the steps below.
1. Open the battery cover case by removing the knob screws on the front
and back of the case and then carefully removing the right side of the
battery case.
2. Move the switch to your desired position. “O” for regular speed and “I“ for
slow speed.
3. Replace the battery cover case. The minibike will have a max speed of
10 mph in the “O” or fast position and 6.8 mph in the “I” or slow position.
Being an electric-powered vehicle, your MBxXSe is a relatively low
maintenance machine. However, it is important to properly care for the unit
to keep it operating properly and safely. Below are items that you will need
to care for on a regular basis.
IT IS CRITICALLY IMPORTANT TO ALWAYS STORE YOUR MBxXSe
INDOORS AND OUT OF THE WEATHER. THE ELECTRICAL SYSTEM IS COVERED
BUT SHOULD NOT BE CONSIDERED SEALED. WATER CAN CAUSE SERIOUS
DAMAGE TO THE POWER TRAIN AND CREATE A DANGEROUS SITUATION.
WATER DAMAGE WILL VOID YOUR WARRANTY.
The drive chain transmits power from the motor to the rear wheel. To work
properly it must be lubricated and properly tensioned at all times.
Check the tension on the drive chain by
moving it up and down approximately
halfway between the sprockets. There should
be no more than 1/2” vertical slack in the
chain. If the chain seems too loose, it may be
in danger of coming off while riding.
To adjust the chain tension, follow the steps
outlined below:
1. Be sure that the minibike is parked on a flat,
level surface and leaning on the kickstand.
2. Using a 15mm wrench, loosen the rear
wheel axle nuts on each side.
3. After the axle nuts are loosened, use a
10mm wrench to turn the sprocket
side tensioner bolt clockwise (to tighten)
about one turn, then repeat this
process on the other side tensioner bolt.
4. Check the tension on the chain and see if
SLOW SPEED SAFETY SWITCH
15
14
MAINTENANCE
STORE INSIDE, OUT OF THE WEATHER
DRIVE CHAIN TENSION
MAINTAINING YOUR MINI BIKE
TROUBLE
?
DO NOT RETURN TO STORE
contact us!
888-488-MOTO (6686)
or email info@motovox.com
10 MPH max (Fast Speed)
6.8 MPH max (Slow Speed)
