Dx350_06d_oi_e.docx / Jul-20
page 7 / 67
Installation
The device is only allowed to be installed and operated within the permissible temperature range. Please
ensure an adequate ventilation and avoid all direct contact between the device and hot or aggressive gases
and liquids.
Before installation or maintenance, the unit must be disconnected from all voltage-sources. Further it must be
ensured that no danger can arise by touching the disconnected voltage-sources.
Devices which are supplied by AC-voltages must be connected exclusively by switches, respectively circuit-
breakers with the low voltage network. The switch or circuit-breaker must be placed as near as possible to the
device and further indicated as separator.
Incoming as well as outgoing wires and wires for extra low voltages (ELV) must be separated from dangerous
electrical cables (SELV circuits) by using a double resp. increased isolation.
All selected wires and isolations must be conform to the provided voltage- and temperature-ranges. Further all
country- and application-specific standards, which are relevant for structure, form and quality of the wires,
must be ensured. Indications about the permissible wire cross-sections for wiring are described in the
Technical Specifications.
Before first start-up it must be ensured that all connections and wires are firmly seated and secured in the
screw terminals. All (inclusively unused) terminals must be fastened by turning the relevant screws clockwise
up to the stop.
Overvoltages at the connections must be limited to values in accordance to the overvoltage category II.
