8
99289GB - GOOUT - REV. 00
N.B. The latchbolt hole for the deadbolt must allow opening
even when the door is subject to pressure (EN 1125).
MINIMUM DIMENSIONS
FIXING THE CYLINDER: For good operation of the lock, we advise you to install a MOTTURA CHAMPIONS® Europrofile double or
half-cylinder (depending on the application). DO NOT use cylinders with knobs. For better protection of the cylinder from outside
the door, we advise you to use MOTTURA DEFENDER® systems.
See MOTTURA catalogs for these articles (not included in the pack).
Cylinder fixing screw
N.B. In case of version with ½ cylinder, use the screw for locks with 30mm thickness (C28B...- C30B...- C38B...- C43B...- C48B...).
The hole on the striker plate for entrance of the latchbolts and deadbolt must have the dimensions shown in the following figure
(see page 4 for distances between centers of latchbolts).
INSIDE HANDLE ONLY
: With 4 screws (ref. V4, not supplied) suitable
for the type/thickness of the door, fix the escutcheon support pla-
te, insert the plastic washer and the escutcheon cover, then fix the
handle with the grub screw.
INSIDE/OUTSIDE HANDLE
: With 2 M6 screws (not supplied) with
length suitable for the thickness of the door, fix the escutcheon sup-
port plates, insert the plastic washer and the escutcheon cover, then
fix the handles with the grub screw.
EMERGENCY HANDLE
UNI EN 179
PANIC-BAR VERSION
UNI EN 1125
EMERGENCY HANDLE
UNI EN 179
V4
M6 UNI 5933
FOR EXAMPLE ONLY
V5
CH 3-4
PH2
