Motus 10 sport pro, Original User Manual

13

a. Power button

Press and hold the power switch for more than 3 seconds to turn on the LED 

screen. The device will turn off automatically if it is not moved within 90 

seconds.

bb. Acceleration and speed

After turning on the device, press the power button. L1 will appear on the 

screen, indicating gear 1 (up to 20 km / h*). Press the power button again and 

the screen will show L2 indicating gear 2 (20 - 40 km / h). Press the power but-

ton again and the screen will display L3 indicating gear 3 (40 - 100 km / h). Hold 

down the power button for 2-3 seconds and the front light will turn on.

To enter the acceleration menu, press the Power key repeatedly until P12 is 

displayed, then press the MODE key to lock the option. Use the power but-

ton to decrease acceleration and the MODE button to increase accelera-

tion from 1 to 5. The higher the number, the greater the acceleration.

d. Display

After turning on the power, the display shows the total distance traveled by 

the device (ODO). Press the power button to display the distance traveled 

since power-on (TRIP); press the power button again, the battery voltage will 

be displayed. When TRIP is displayed, holding the MODE key for three se-

conds will reset the TRIP data.

Speed

Battery indicator

(POWER) switch

MODE button

Throttle

Thanks to the shifter, the user can 

control the speed depending on 

the current situation.

Handle - grab the handles to steer the device. Do not take your hands off the 

steering wheel while driving.

e. Battery charge level.

The number of bars indicates the battery charge status.

Note: Charge the battery when only one bar appears on the display, as over 

discharging may damage the battery.

4.2 Battery properties and charging

Charging

1. Connect the charger to an AC mains.

2. Connect the Electric Scooter to the charger.

3. Full charging takes approximately 10 - 12 hours

4. The ideal charging temperature is 5-40 ° C. If the cells’ temperature is out 

of range, the battery management system will stop the charging process.

Battery properties

1. Balanced charging protection: The construction of the battery is designed 

to automatically balance the voltage of the internal cells and thus protect the 

battery.

2. Overcharge Protection: Overcharging can seriously damage the battery. 

After the battery is fully charged, the charging process will be automatically 

interrupted by the control board.

3. Charging temperature: The battery may be damaged or malfunctioning if 

it is charged in an ambient temperature below 5 degrees Celsius or above 40 

degrees Celsius.

4. The ideal charging temperature is 5-40 ° C. If the cells’ temperature is out 

of range, the battery management system will stop the charging process.

Battery properties

1. Balanced charging protection: The construction of the battery is designed 

to automatically balance the voltage of the internal cells and thus protect the