14
procedures as 4) thru 8).
10) Remove the PULLEY (19) combined with the Shaft by taking it out toward the front of the
Machine.
11) Remove the PULLEY BELT (22).
12) Install the new PULLETY BELT (22) in reverse order.
13) If needed, adjust the Pulley Belt Tension. See “2.2 How to Adjust the Drive Belt (or Pulley
Belt) Tension”
2.4 How to Replace the Generator
1) Disconnect two cables from the
GENERATOR.
2) Loosen two HEX LOCK NUTs (11) a little
using 17mm spanner. See “2.3 How to
Replace the Drive Belt”
3) To loosen the PULLEY BELT (22), turn
HEX NUT (21) counterclockwise with a
19mm spanner while holding H/S HEX BOLT
(12) with another 19mm spanner. See “2.3
How to Replace the Drive Belt”
4) Derail the slackened PULLEY BELT (22) from the PULLEY (19). See “2.3 How to Replace
the Drive Belt”
5) Remove ALLEN BOLT (15), HEX LOCK NUT (16) and PLANE WASHER (17) securing the
GENERATOR (14) to the GENERATOR FRAME (9) by using 4mm wrench and 10 mm spanner.
6) Remove the GENERATOR (14) from the GENERATOR FRAME (9).
7) Install new the GENERATOR (14) in reverse order.
8) If needed, adjust the Pulley Belt Tension. See “2.2 How to Adjust the Drive Belt (or Pulley
Belt) Tension”
Summary of Contents for M770E
