51
EN
ASSEMBLING AND FITTING THE ON THE GO BOTTLE
Moisten the seal (E3) (even if already fitted on the blades unit (E4)). Be careful to correctly fit
the seal back onto the blades unit (E4) the correct way up (Fig 9).
Check the seal is in place on the blades unit.
Add the ingredients into the bottle without exceeding the maximum level indicated:
* 400ml for thick mixtures
* 600ml for liquid preparations
Warning : Do not pour boiling liquids (over 80°C/176°F) into the bottle.
Place the blades unit (E4) on the top of the bottle, fit the locking ring (E5), and lock it by
rotating to lock notch in the clockwise direction (Fig. 8).
Make sure the blades unit is locked correctly : the arrow on the locking ring should be aligned
with the arrow on the bottle.
Turn the bottle upside down and position it correctly on the motor unit. Lock it by rotating it in
the clockwise direction. A bottle logo will appear on the screen and a bip signal will sound
.
USING YOUR APPLIANCE
Put the appliance on a flat, stable, heat-resistant surface away from heat sources or water
splashes
Plug your appliance and select your program or manual settings (time and speed) and press the
start/ stop button : with the Jar (A) you can change the blending speed from 1 to 9 by pressing
the s/- buttons (L). « H »is the maximum speed. You can also set up the working time by
pressing the s/- buttons (L) between 5 seconds and 3 minutes. With the On The Go bottle
(E) you can manage the blending speed from 1 to 7 by pressing the s/- buttons (L). You
can also set up the working time by pressing the s/- buttons (L) beteen 5 seconds and
90 seconds.
(Fig 2). Lock it by rotating to lock notch in the clockwise direction (Fig. 2). Make sure the locking
ring is locked correctly : the arrow on the jar must be aligned with the arrow on the locking ring.
Add the ingredients into the assembled jar without exceeding the maximum level indicated:
* 1.75 L for thick mixtures
* 1.5 L for liquid preparations
Warning : Do not pour boiling liquids (over 80°C/176°F) into the jar
Lock the lid on the jar and lock in the clockwise direction (Fig 5). Make sure the lid is locked
correctly : the point on the lid should be aligned with point on the handle. Lock the middle cap in
position on the lid and lock it by rotating it in the clockwise direction. If the lid is not correctly
locked, your appliance will not start; Position the jar correctly on the motor unit : the point on
the jar should aligned with the lock on the motor unit. A jar logo will appear on the screen and
a bip signal will sound.
