EN
15
• Read the instructions for use carefully before using your appliance for the first time: the manufacture shall accept no
liability in the event of any use that does not comply with the instructions.
• This appliance is not designed to be used by persons (including children) with reduced physical, sensorial or mental
capacities, or by people with no prior knowledge or experience, except where they have benefited from supervision
or previous instructions relating to the use of the appliance, from a person responsible for their safety. Children must
be supervised to ensure that they do not play with the appliance.
• Check that the power rating of your appliance corresponds to your electrical supply.
Any connection fault
invalidates the warranty.
• Your appliance is intended only for domestic culinary use, in an indoor setting and under supervision.
• Always unplug the appliance as soon as you have finished using it and when you are cleaning it.
• Do not use the appliance if it is not working properly or if it has been damaged. Contact an authorised service centre
(see list in the service booklet).
• Any maintenance other than routine cleaning and upkeep by customers must be carried out by an approved service
centre (see list in the service booklet).
• Do not place the appliance, the supply cable or the plug in water or any other liquid.
• The power cord must be kept out of the reach of children and must not be placed near or come into contact with the
hot parts of the appliance, sources of heat or sharp corners.
• If the power cable or the plug are damaged, do not use the appliance. To maintain safety, these parts must be
replaced by an approved service centre (see list in the service booklet).
• Do not place the accessories in a microwave oven.
• For your own safety, use only accessories and spare parts designed for your appliance and sold in an approved
service centre.
• Always remove the blender (d) or the juice extractor (h) before pressing the multi-function head (a3) release button (a2).
• Always use the pusher (f7) with the mincer head accessory (f), to guide food in the feed tube. Never use your
fingers, a fork, a spoon, a knife or any other object.
• Never touch any moving parts. Wait for the appliance to come to a complete stop before removing accessories.
• Handle the sharp blades (d, f, g) carefully when emptying the bowls and when cleaning: they are extremely sharp.
• Do not touch the whisks or the kneader when the appliance is running.
• Do not allow long hair, scarves, ties etc. to dangle over the appliance during operation.
• Never insert utensils (spoon, spatula, etc.) through the feed tube in the lids (b2), (d2) or (h2) in the drum body (g1).
• Do not run the blender jug (d1) without its lid (d2).
• Use only one accessory at a time.
• Do not use the bowls (b1, d1) as containers for freezing, cooking or sterilisation.
• Do not use the juice extractor if the rotary filter (h3) is damaged.
• Switch off the appliance and unplug from the mains supply before changing accessories or handling any parts that
move during use.
• Before using for the first time, wash all accessory parts in soapy water (except for the attachment (e): see §
Cleaning) Rinse and dry.
• Place the appliance on a flat, clean and dry surface. Make sure that the selector button (a1) is in “0” position and
plug in your appliance.
• You have several options for starting your appliance:
-
Intermittent operation (pulse):
Turn the selector button (a1) to the “pulse” position. Using a succession of
pulses can give you better control when preparing certain foods.
-
Continuous operation:
Turn the selector button (a1) to the desired position from “1” to “max” depending on the
food you are preparing.
You can change it as required during preparation.
• To stop the appliance, turn the button (a1) to “0”.
Important: The appliance will start only if the cover (a5) and the head (a3) are locked. The appliance will stop
immediately if you unlock the cover (a5) and/or the head (a3) during operation. Lock the cover and/or the
head, turn the control button (a1) to the “0” position, and then start the appliance normally by selecting the
desired speed.
Your appliance comes with a microprocessor that controls and analyses the operating power.
If the load becomes
too high, your appliance will stop automatically.
To restart your appliance, turn the rotary button (a1) to the “0”
position and remove some of your ingredients. Allow your appliance to cool down for a few minutes. You can then
select the desired speed to complete your preparation.
SAFETY INSTRUCTIONS
BEFORE FIRST USE
MO_8080012363-01-Middle East_IM_FR_EN_TR_AR_FA_V8.indd 15
22/02/2013 6:11 PM
