THANK YOU
for your purchase of the Pro Feeder. Please read this
sheet before assembling the unit. If you should have any questions
about this product or any other Moultrie product, please contact us
using the information on the back of this sheet. To help us to better
serve you, please complete and mail the enclosed Registration Card.
ASSEMBLING UNIT
Instructions for Pro Feeder
LEGS:
With Feeder lying on side, position
Leg
at
desired height and align holes in
Leg
with holes in
Bottom
as shown. Attach
Leg
using three provided
1/4” x 3/4” bolts. Repeat for all four
Legs
- carefully
rotating enclosure. Stand-up Feeder after all
Legs
are
attached.
HANDLE:
Slide provided
#8 x 1/2”
screws through
four holes in
Handle
and into Lid as shown. Place
provided four
Rubber O-rings
onto bottom of screws
followed by
Nylon Nuts
. Tighten nuts until
Handle
is
secure.
CONTROL BOX:
Place the
Control Box
inside the
Feeder and align four threaded sleeves with holes in side
wall of Feeder as shown. Secure
Control Box
to the
Feeder Wall
using four provided
#8 x 1/2” Screws
.
Peel the adhesive backing from the
Wire Straps
and
secure the wire against the side wall of the Feeder as
shown.
Route the thin black
Remote Control Antenna Wire
through the rubber grommet to the outside of the Feeder
Wall. Roll the
Antenna Wire
into an approximate 6”
diameter loop and wire-tie it close to the rubber grommet
as shown.
The additional connector on the Control Box is provided
for the Moultrie Solar Panel upgrade (MFH-DSP). The
Solar Panel will greatly extend battery life and may be
purchased at a Moultrie Distributor or by calling Moultrie
using the telephone number on the back side of this sheet.
The Pro Feeder may be used for distributing fish food or corn. The Pro Feeder is shipped with the
Bottom Section inside the Top Section. Carefully remove the bolt packs, Control Box, Battery,
Charger, and Legs from inside the unit and place them on the ground. Slide the Bottom Section out of
the Top Section using the attached zip-tie handles . Cut-off zip-ties when complete.
METAL ENCLOSURE:
Place
Top Section
on ground with the
Flange
up. Remove the backing
from the provided Gaskets. Align the holes in the Gaskets with the holes in the flange in the
Top
Section.
Orient
Top Section
onto
Bottom Section
with
Viewing Window
(Top) on opposite side
from
Feed Door
(Bottom) as shown. Attach
Top Section
to
Bottom Section
using provided 1/4”
x 3/4” bolts.
Top section
has Viewing
Window
Bottom section
has vent holes
Feed Door (not shown)
on opposite side from
Viewing Window
Three screws
per leg
Leg may be
positioned to
desired height
Handle
Lid
Foam Gasket
Top Section -
Bottom View
Lid
Screw
Nylon Nut
Rubber O-Ring
Flange
Adhesive Backed
Wire Straps
(inside Feeder)
Remote
Control
Antenna
Wire in
loop
#8 x 1/2”
Screws (4)
Control Box
(inside Feeder)
