Mountain Fresh
PURE WATER
5.
Remove the cartridge from the bracket & replace with the new one.
6.
Insert the elbow stems into each end of the new cartridge until secure.
7.
Turn the water back on at the JG TAP & press the bubbler to let the water flow. Unless previously flushed, the
water will run black for a few seconds, while it clears of carbon fines. Flush for a couple of minutes until the
water is crystal clear.
8.
Check for leaks, before replacing the lower plate.
9.
You can adjust the flow with a screwdriver on the side of the bubbler, circled below. If the flow remains too
powerful, it can be reduced by slightly closing the JG TAP.
Enjoy crystal clear, filtered water for another year.
Remember, if you need assistance, Mountain Fresh are
always here to help.
Call us on 0800 PURE H20 (0800 787 342)
