3.Choose one of the following:
a. Press the Menu/Power button to return to Standby mode.
b. Press “PTT” button to save the setting and return to Standby
mode.
Dual watch receiver [dual scan]
without pushing the “PTT” button. The radio with Room Monitor enabled
is not capable of receiving any transmissions.
To turn Room Monitor ON/OFF
1. Press “MENU” button until the Room “Monitor” icon blinks.
2. Press the "UP" or "DOWN" button to turn the room monitor On or Off.
3. Choose one of the following:
a. Press the “MENU” button to enter the new setting and
proceed to other functions.
b. Press “PTT” button to save the setting and return to Stanby
mode.
Note:
To set Room Monitor sensitivity
2. Press the “UP” or “DOWN” button to change the setting.
3. Choose one of the following:
a. Press the Menu/Power button to enter the new setting and
proceed to other functions.
b. Press “PTT” button to save the setting and return to Standby mode.
To turn Key Tone & Roger Beep On or Off
10
11
When the voice or noise in the monitored room continues
for more than 60 seconds, the monitoring radio will
discontinue monitoring for 5 seconds, then resume.
1. Press the "MENU" button until the Room Monitor sensitivity icon
"b" flashes and the current sensitivity level is displayed.
1. Press the "MENU" button until “P” (the Key Tone & Roger Beep) icon
flashes on the display. The current On or Off setting is displayed.
2. Press the “UP” or “DOWN” button to turn Key Tone & Roger Beep On or Off.
With Dual Watch mode enabled, the radio listens for transmissions on two
separate channels—the main (home) channel, and the channel set in Dual
Watch mode. The Dual Watch mode enabled is indicated by the "2CH" icon.
When there is no signal in either the main channel or Dual Watch channel in
Standby mode, the main channel will be indicated by the display. When the
main channel is active, the display will not change. When the Dual Watch
channel is active, the display will show the Dual Watch channel. After 5
seconds of no activity on the Dual Watch channel, the display will revert to the
main channel.
To set Dual Watch Mode
1. Press "MENU" button until the "2CH" icon is displayed.
2. Press the "UP" or "DOWN" button to select the channel you wish to monitor in
addition to the main channel. The interference eliminator code (sub-code) is
dictated by that channel's sub-code as selected in the main channel
selection, and cannot be changed here.
3. Choose one of the following:
a. Press the "MENU" button to enter the new setting and proceed to other
functions.
b. Press “PTT” button to save the setting and return to Standby mode.
