28
Operation is only allowed with a safety switch against
stray current (RCD max. stray current of 30mA).
Check the voltage. Technical data given on the type la-
bel must correspond with electric network voltage.
Insert the plug of the electrical cable in a socket of sui-
table shape, voltage and frequency complying with cu-
rrent regulations.
Pursuant to the provisions of „CE“ professional associations,
etc., all splitters are fitted with an undervoltage release in the
switch. This will prevent accidental repeated starting in case
of current interruption due to power failure, accidental unplu-
gging, defective fuse, etc. The machine must necessarily be
turned on again by repeated pressing of the green switch.
Wilful holding or blocking of the switch, unless being
a neutral, will automatically lead to switch failure.
The warranty will not apply in such a case that must
naturally be checked.
Working area
For safe wood splitting, it is essential that the working
area is flat and slip-resistant and that a sufficient space
for moving is provided. To take the wood splitter to your
home, it is necessary there are no obstacles in the way,
i.e. no risk of tripping. Adequate lighting of the working
area needs to be provided.
When being operated, the machine must stand on a ho-
rizontal and flat surface and the floor around the machi-
ne must be flat, well-maintained and with no waste, such
as sawdust and cuttings.
Emergency procedure
Conduct a first-aid procedure adequate to the injury and
summon qualified medical attendance as quickly as po-
ssible. Protect the injured person from further harm and
calm them down. If you seek help, state the following
pieces of information: 1. Accident site, 2. Accident type,
3. Number of injured persons, 4. Injury type(s)
Transport
The wood splitter is equipped with transport wheels.
To transport the wood splitter, grab the wood splitter's
front transport handle and lift it. Then the wood splitter
can be easily transported. There is an bleeding screw on
the rear side of the machine. It must be tightened befo-
re transporting the machine to prevent oil leakage. The
log pusher is automatically retracted back to its starting
position.
Start-up
Check that the machine is completely and correctly as-
sembled.
Before using the shredder, make sure each time that
• there are no faulty connections (tears, cuts, etc.)
• there are no damage at the machine
• all screws are tight
• check the hydraulic system for any possible leaks
Mains connection
• Compare the voltage given on the machine mo-
del plate e.g. 230 V with the mains voltage and
connect the machine to the relevant and properly
earthed plug.
• Only use connection cables with sufficient diame-
ters.
• Connect the machine via a 30 mA fault current
safety switch.
Fuse protection: 16 A
Operating pushbutton
Operating pushbutton
Switching on
Push the green button. The motor is running as long as
the green button remains pushed.
Switching off
Stop pushing the green button.
Do not use any device where the operating
pushbutton does not work properly. Repair or
replace damaged pushbuttons immediately.
Hydraulics
• Never operate the machine in the event of any
possible danger from hydraulic fluid.
• Ensure that the machine and working area are
clean and free of oil. Danger of slippage or fire!
• Check the hydraulic reservoir regularly to ensure
that it contains enough hydraulic oil
Capacity: 3,2 litres
Working with the log splitter
additional SAFETY INSTRUCTIONS
• The log splitter may only be operated by a single
person.
• The machine may only be operated by persons
over the age of 18 years, and who have read and
understood these operating instructions.
• Wear protective equipment (safety goggles/mask,
gloves, safety shoes) to protect yourself from po-
ssible injury.
• Never try to split logs containing nails, wire or other
similar objects.
• Already split wood and wood chips create a dan-
gerous working area. The operator may stumble,
slip or fall.
Always keep the working area neat and tidy.
Summary of Contents for PATRIOT 5T
