25
See page 39
• The electrical connection must be perfor
med in accordance with ČSN IEC 60245
(for example H07RNF) with a minimum wire
crosssection of:
− 1.5 mm
2
for max. cable length of 25 m
− 2.5 mm
2
for cable length over 25 m (up to
approx. 40 m)
• Long and thin connecting wires cause loss of
voltage. The motor is then not able to provide
its maximum power output and the machine's
performance will be diminished.
• When using a cable reel, unwind the entire
length of the cable.
• Connecting plugs and sockets must be made
of rubber, flexible PVC or other thermoplastic
material with the same mechanical strength, or
must be coated with this material.
• The power supply cable plug must be protec
ted from splashing water.
• The cable must be routed so that it will not be
broken or crushed, and the plug must not be
placed in wet areas.
• Do not use the cable for purposes other
than what it is intended for. Protect the cable
against heat, oil and sharp edges. Do not use
the cable to pull out the plug.
• Periodically check the cable and replace it if
damaged.
• Do not touch damaged electrical components
or wires until the machine is disconnected from
the power supply.
• Never use a damaged power supply cable.
• When using the machine outside, use only
cables approved and properly marked for this
purpose.
• Never use a makeshift electrical connection.
• Never bypass or disable the circuit breakers.
• The machine connection must be performed
through an overcurrent circuit breaker (30 mA).
Electrical connection and repairs of elec
trical components can only be performed
by a qualified electrician. In doing so, the
local regulations, especially those related to
safety measures, must be observed.
Repairs of other machine parts must be
performed by the manufacturer or an autho
rised service centre.
Installation
Electrical Safety
Use only original spare parts. Using other
spare parts and/or accessories can result
in injury to the user. The manufacturer is re
lieved of any responsibility for any resulting
damage.
If the power supply cable needs to be chan
ged, this must be carried out by the manufac
turer or its authorised representative to avoid
any safety risk.
UK
