Then place assembled wall plate
along the centerlines and use
pencil to mark 4 hole locations on
the wall.
Use 7/32" diameter drill bit to drill 4
pilot holes at marked positions to a
depth of 2.5".
Put 4 lag bolts (H) through the
washers (J) into the drilled holes,and
tighten each bolt by using a socket
wrench to mount the assembled wall
plate securely. Before totally tightening
the lag bolt please attach the bubble
level on the wall plate to check
whether it is level.
(7/32")
J
H
drywall with
wood stud
spacing from
18" to 24"
Step 2 Wall plate installation
:
Wall plate installation in wood stud
To avoid potential body injury or property damage:
1. Wall mount must be installed into wood stud's center, not drywall alone.
2. Drywall covering the wood stud must not exceed 16 mm (5/8 in.).
3. Minimum wood stud size: common 2 x 4 in(51 x 102 mm). Nominal 1 1/2 x 3 1/2 in(38 x 89mm)
4. The wall must be capable of supporting five times the weight of TV plus mount.
5. Make sure the logo on wall plate is upward as picture shows.
6. All lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate.
Ensure the wall plate is securely fastened to the wall before continuing on to the next step.
Failure to follow this instruction will possibly lead to TV falling off from wall, and would possibly
cause body injuries or property loss.
CAUTION
<16 mm(5/8 in.)
Locate the stud
with stud finder. Make
marks at the edges
of stud.
Mark centerlines
of stud.
①
②
③
④
⑤
②
