Mountz Inc.
1080 North 11th Street, San Jose, CA 95112 Phone: (408) 292-2214 Fax: (408) 292-2733
www.mountztorque.com
Page 6
Try one screw and make sure it runs smothly thruout the rail. Than re tight all
screws on the rail.
Quantity of screws thrown in
If too many screws are thrown in, orientation and transfer of the screw
might be
affected.
Check/adjustment of the brush
Check the height of the brush.
*As in the picture above, set the brush to an approximately level position.
*
Make sure
the edge of the brush
tauches
the screw's head.
*If the height of the brush is either too low or too high, orientation and transfer of the screws
might get jammed or it won't feed any screws.
*If adjustment is necessary, adjust it by loosening the brush height adjusting screw.
Note:
Always unplug the AC adapter from the wall outlet before making any adjustments to
avoid injury.
Loosen
screws as indicated. Use the metal laminates provided as
accessories to increase width on the rail.
