Mountz Inc.
1080 North 11th Street, San Jose, CA 95112 Phone: (408) 292-2214 Fax: (408) 292-2733 www.mountztorque.com
Page 14
Trouble Shooting
Problem
Reasons
solution
No power
1.
2.
power supply is damaged
switch damage
Check for updates
Indicator lit but the
1.
Sensor in wrong location or blocked
1.Check or adjust
2.Re-welding
3.Remove them
machine
form
the
machine does not
2.The power cord outlet is broken
work
3.Working part of the machine is blocked
Screw is stuck in
Screw Chamber
Screw Windows open or
brush position is wrong
Check and adjust
Screw leak out from
the container
Screw Windows open or
brush position is wrong
Check and adjust
Vibration, no stop
1.
2.
3.
Feeding delay is too long
sensor located in wrong location
sensor is not in the right position
Check and adjust
Sensor is not in
position
the
right
Screw on rail speed
is too slow
1.
2.
3.
4.
5.
6.
Feeding speed is slow and delay Is
too short
The gap of the rail is not suitable
The rail touches the board
No gap between rail and front board There
are dropped Screws between vibration
motor and bottom board
1.adjust the motor speed
2.Increase the feeding delay
