Recharging Batteries (internal NimH batteries):
1. Plug the RS232/Power cable in the back of the wrench.
2. Plug the RS232 adapter into the other end of the Data/Power cable.
3. Plug the transformer into the back of the Rs232/Power adapter.
Notes:
- The operator can use the wrench when the power adapter is charging the batteries.
- The operator can use the wrench on external power without batteries.
- The operator can charge the batteries while the Rs232/Power adapter is plugged into a computer (while you are
sending data to the computer).
Hyperterminal:
1. To Open Hyperterminal Select: A) Start...B) Programs...C) Accessories...D) Communications...E) Communications
2. Name the new file
3. Select Properties
4. Select Connect: Com X(Where X is the active com port)
5. Select Configure
6. Set parameters as shown
7. Select Connect
RETW Operation instructions
Page 5
Mountz Inc.
www.etorque.com
2
3
1