MCS Hand Set Features:
-
Located on the MCS handset behind the zoom knob is a red multifunction button. This button is
designed for two functions.
o
Pressing and holding down this button will access the zoom speed as well as ZAP function on the
display. Once in this screen quick press the button to return to the main screen.
o
Range limit of the motor travel can be programed with a quick press of this button.
Select the function to be limited (Focus, Iris, or zoom).
Located on the MCS screen on the lower left is “LIMIT”. Touch to access the
selection screen and select the function desired.
Go to your start point and quick press. A line should now appear next to the distance
marking.
Go to your end point and quick press. A solid line should now appear next to the scale
from your start point to end point programed. Now the motor is limited to travel within
this range.
To clear limit settings, quick press and the solid line should now disappear.
-
Marker points can be programed into the focus scale.
o
Quick press the blue center button located on the lower bottom of the screen.
o
The lower screen should now display ( “MARKER”, “Remove”, “Back” )
o
Go to your first mark point and press marker. A colored arrow should now appear next to the
distance point.
o
Repeat step above to add each additional point.
A maximum of 10 marker points can be assigned with each displaying a different color.
o
To remove the markers, go to each marker point and press remove.
-
The MCS is able to accept lens mapping. If no mapping is done, scale display can be changed to represent
percentage. To enable percentage follow the steps:
o
Press “Menu”
o
Press “Camera & Lens”
o
Press the dot next to “Percentage”
o
If percentage is selected the dot will be blue. Press again to disable.
-
The MCS hand wheel features adjustable dampening. To adjust follow the steps:
o
Remove the focus scale and locate the hole just above the detent/key pin on the hand wheel.
Located inside the hole is a 2.5mm hex head screw.
o
Using a 2.5mm hex wrench, rotate the screw.
Clockwise will increase tension.
Counter clockwise will decrease tension.
o
Once adjusted, replace the scale.
