AirWorks AWK-3131-RCC
Introduction
1-6
LED Indicators
The LEDs on the front panel of the AWK-3131-RCC provide a quick and easy means of determining the current
operational status and wireless settings.
The FAULT LED indicates system failures and user-configured events. If the AWK-3131-RCC cannot retrieve
the IP address from a DHCP server, the FAULT LED will blink at one second intervals. The SIGNAL LEDs
indicate signal strength, and only operate in Client mode.
The following table summarizes how to read the device’s wireless settings from the LED displays. More
information is available in Chapter 3 in the “Basic Wireless Settings” section.
LED
Color
State
Description
PWR1
Green
ON
Power is being supplied from power input 1
OFF
Power is not being supplied from power input 1
PWR2
Green
ON
Power is being supplied from power input 2
OFF
Power is not being supplied from power input 2
PoE
Amber
ON
Power is being supplied via PoE
OFF
Power is not being supplied via PoE
FAULT
Red
Blinking (slow)
Cannot get an IP address from the DHCPserver (interval: 1
sec)
Blinking (fast) IP address conflict (interval: 0.5 sec)
Off
Error condition does not exist
STATE
Green/
Red
Green
Software ready
Green,
Blinking
The AWK has been located by the AWK STATE Green/Red
Search Utility (interval: 1 sec)
Red
Booting error condition
SIGNAL On
(5 LEDs)
Green
ON
Signal level (for Client/Slave mode only)
OFF
WLAN
Green/
Amber
Green On
WLAN functions in Client/Slave/ACC mode
Green, Blinking WLAN’s data communication is run in Client/Slave/ACC mode
Amber On
WLAN functions in AP/Master/ACC mode
Amber, Blinking WLAN’s data communication is run in AP/Master/ACC mode
Off
WLAN is not in use or not working properly
LAN
Green/
Amber
Amber
LAN port’s 10/100 Mbps link is active.
Amber, Blinking Data is being transmitted at 10/100 Mbps
Amber Off
LAN port’s 10/100 Mbps link is inactive
Green
LAN port’s 1000 Mbps link is active.
Green, Blinking Data is being transmitted at 1000 Mbps
Green Off
LAN port’s 1000 Mbps link is inactive
www.ipc2u.ru
www.moxa.pro