C320Turbo/PCIEL
Hardware Installation
2-5
adapter, which are described as follows:
Without power adapter (for normal condition)
In most cases, you will not need a power adapter.
A: Set the Basic Module power switch to the OFF position. This is absolutely necessary when
installing or removing the cable, the Basic Module, or the Extensive Module(s). Power should
not be switched on until you have installed all components.
B:
Connect the card power socket to the PC power supply with an IDE power cable.
C: Plug the DB25 (male) of the 25-pin cable into the connector on the rear panel of the Intellio
C320Turbo/PCIEL Control Board. Refer to chapter 5 for cable pinout.
D: Plug the DB25 (female) cable into the CPU Module.
F: Replace the system cover.
With power adapter (for range extension/external power condition)
In case of range extension or external power requirement, you will need a power adapter.
A: Set the CPU Module power switch to the OFF position. This is absolutely necessary when
installing or removing the cable, the CPU Module or the UART Module(s). Power should not be
switched on until you have installed all components.
B: Plug the DB25 (male) connector of the 10-pin cable into the connector on the rear panel of the
Intellio C320Turbo/PCIEL Control Board.
C: Plug the DB25 (female) connector into the CPU Module.
