- 6 -
DIN-rail Mounting
When shipped, the DIN-rail mounting kit is fixed to the back panel of the
EDS. Mount the EDS on the corrosion-free mounting rail that adheres to
the EN 60715 standard.
Suggested Installation Method
STEP 1:
Insert the upper lip of the DIN-rail
kit into the mounting rail.
STEP 2:
Press the device towards the
mounting rail until it snaps into
place. Alternatively, you can use a
screwdriver to attach to the
bottom of the DIN-rail kit and pull
down.
Suggested Removal Method
STEP 1:
Pull down the latch on the DIN-rail
kit with a screwdriver.
STEP 2:
Slightly pull the device forward
and lift up to remove it from the
mounting rail.
NOTE
1.
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired.
2.
The installation and the safety of any system incorporating
the equipment is the responsibility of the assembler of the
system.
3.
This is an OPEN TYPE module and should be installed in a
safety enclosure with mechanical rigidity and an appropriate
IP rating.
