—
9
—
Wiring the Redundant Power Inputs
The top two contacts and the bottom two contacts of the 6-contact terminal block connector on
EDS’s top panel are used for EDS’s two DC inputs. Top and front views of one of the terminal
block connectors are shown here.
Top View
Front View
STEP 1
: Insert the negative/positive DC wires into the
V-/V+ terminals.
STEP 2
: To keep the DC wires from pulling loose, use
a small flat-blade screwdriver to tighten the
wire-clamp screws on the front of the terminal block
connector.
STEP 3
: Insert the plastic terminal block connector
prongs into the terminal block receptor, which is
located on EDS’s top panel.
ATTENTION
Before connecting EDS to the DC power inputs, make sure the DC power source voltage is stable.
