EXPC-1319 Series Hardware
Hardware Installation
2-4
NOTE
To make sure the panel computer will be securely installed on the yoke, use M4 screws. The screw holes
penetrate 8 mm into the computer’s case. When choosing screws for installation, remember to account for the
thickness of the mounting surface. Refer to
Appendix B: Statement of Regulatory Approval
for the
technical details regarding regulation Class 1 Div. 2 devices.
Panel Mounting
Follow these steps to install the EXPC-1319 on a panel cabinet.
1.
Place the gasket between the EXPC-1319 and the enclosure, and use eight M6 screws to penetrate the
enclosure and gasket, so that the gasket can be securely fasten on two sides of the panel mounting holes
on the back of the EXPC-1319.
NOTE
To make sure the panel computer will remain securely installed in the cabinet, use M6 screws of a suitable
length. The screw holes penetrate 6 mm into the computer’s case. When choosing screws for installation,
remember to account for the thickness of the mounting surface.
2.
Install the mounting brackets from inner part of the computer, and use M4 screws to fasten the brackets.
Four screws are required per side.
NOTE
For the installation in hazardous environments, refer to Explosion Hazard section in Appendix B.
