ioLogik W5300
Getting Started
2-9
DIN Rail / Wall Mounting
The ioLogik W5300’s built-in mounting appendages are suitable for mounting on a flat wall or installing on a
DIN rail. Follow the instructions in the figures below to install the W5300 on a DIN rail.
STEP 1:
Insert the top
of the DIN rail into the
slot.
STEP 2:
The DIN rail
attachment unit will
snap into place as
shown at right.
Installing/Removing SIM and SD Cards
The ioLogik is equipped with two slots; one is for SIM cards and the other is for SD cards. The card reader slots
are protected inside the ioLogik device. You will need to unscrew and remove the card cover to install your SIM
and SD cards. When inserting an SD or SIM card, remember to keep the chipped side of the card facing down.
Follow these steps to remove or install a SIM or SD card:
1.
Remove the screw holding the card cover in place.
2.
There are two different card slot types used on the ioLogik series of devices:
(a) On ioLogik W5312 and W5340 models, directly insert or remove the SIM/SD card into the respective slot
(b) On the ioLogik W5340-HSPA you must first depress the card-locking mechanism to eject the card. Use
a pointed instrument like a ball-point pen to depresss the small yellow button at the side of the card slot.
This ejects the card tray, from which you may then insert or remove a SIM card.
ATTENTION
We strongly recommend using the following SD cards, which have been tested in our laboratory:
•
Kingston SDHC 4/16/32 GB
•
Transcend SDHC 4/8/32 GB
•
Innodisk SD6 2/4/8 GB (These Innodisk SD cards are classified as wide-temperature products.)
The function is dependent on the firmware version. Be sure to use firmware version V1.3 or above for the
ioLogik W5312 series, and V1.5 or above for the ioLogik W5340 series.
3