ioLogik W5300
Utility: ioAdmin
3-10
Server Settings Panel (General)
Click the
Server Settings
tab to log in as an ioAdmin
administrator. This is required to gain access to the
ioLogik configuration options. If a password has not
been set up, simply click
Login
and leave the
Password
field blank.
Message Monitor Panel (General)
The
Message Monitor
will
display any TCP/UDP
Active
Messages
reported by the
ioLogik W5300. When you
install the unit for the first time,
the ruleset will not have been
defined yet, so there will be no
messages on the monitor.
When a ruleset has been
defined and activated, any
TCP/UDP messages that have
been triggered by sensor
events will be shown on the
monitor.
Messages can be displayed in ASCII, HEX, or 2-byte Unicode (UCS2). To select your preferred code, check the
appropriate button at the bottom of the window.
Unicode
supports multiple languages.
Synchronization Rate Status Bar
The current sync rate is displayed on the bar at the bottom of the window. The number shows how often the
ioLogik is polled for device status from the ioAdmin utility. The rate can be adjusted by clicking
Menu Bar
System
I/O Status Refresh Rate
. Higher sync rates result in a higher network load.
ioAdmin Status Bar
The status bar shows
ioAdmin status
information, such as
program status (ready,
searching), ioLogik I/O
details, and system time.